This is an oem hood pin switch that I bought off ebay. It came from an 02 Nissan Altima. I have it in the vice so that i can take the switch apart and use it for my custom application.
Viewed: 315 times.
|
This is the hood pin switch connector, separated from the switch itself.
Viewed: 267 times.
|
Now I've made an adapter to plug-in between my hood pin switch in the G and it's harness... this way I don't have to splice any factory wiring.
Viewed: 232 times.
|
Tough working with a cheap iron :(
Viewed: 194 times.
|
The first bracket. This bracket will hold and LED behind the fluid containers (power steering, coolant, and windshield washer). By becoming back-lit, fluid levels will be very easy to check.
Viewed: 210 times.
|
Same as previous bracket.
Viewed: 153 times.
|
Oznium LED with automotive grade disconnect soldered on. Contacts sealed with liquid electrical tape.
Viewed: 254 times.
|
Bracket to hold an LED to shine light on the belt area. This bracket mounts to the unused threaded hole in the part of the intake that is attached to the airbox to gather more air.
Viewed: 246 times.
|
Here it is in action :)
Viewed: 264 times.
|
Experimenting with wiring harness layout.
Viewed: 298 times.
|
"T" wiring harness...
Left: to relay
Right: To two LEDs
Down: To one LED
Viewed: 268 times.
|
LEDs ready to be installed onto brackets. Need to prime and paint the brackets first.
Viewed: 206 times.
|
I couldn't figure out how to get my relay working so I took it to a car audio place and they knew how to hook it up right away :)
Viewed: 237 times.
|
Unfortunately, they had to splice into my oem harness :(
Viewed: 246 times.
|
I used this stuff to patch the exposed wire (I removed the crimp)
Viewed: 198 times.
|
